Micro Failsafe

Code: 4401515

€15·99

On order with supplier

The car saver is designed to return the throttle servo to a pre-set position in the event that the radio signal is lost or the receiver battery voltage drops below a factory pre-set voltage. When used in RC cars it is recommended that full brakes be programmed at the fail safe position. Equipped with Futaba-style plugs.
Just 5 grams including leads and only slightly bigger than a Futaba female plug!

• Computer controlled micro failsafe
• Computer controlled micro low battery indicator
• 2 programmable micro devices in 1 unit
• Ideal for aircraft and helis
• Ideal for RC cars
• Weight - 5 grams including leads!
• Size - 26 x 12 x 5mm
• Operating Voltage - 4.8v & 6.0v

Operation:

• Install between the receiver and the servo you wish to control
• Turn on transmitter and receiver - the unit will blink
• If used in a car, set the amount of brake required at failsafe
• Push and release the SET button (see picture) whilst using the Tx to hold the required brake setting - unit is set
• Test operation by turning off Tx
• Servo should move to the preset position
• Turn Tx on and the radio should respond normally after a small delay